Professional metal roof coating for New Ulm property owners. Lapolla Industries delivers lasting results with industry-leading SPF technology.
Metal roofs in New Ulm, MN leak at fasteners, seams, and panel overlaps — and rust compounds the problem over time. Lapolla Industries applies elastomeric coating systems that seal every failure point, treat existing rust, and create a continuous waterproof membrane over your entire metal roof.
In New Ulm, MN, the difference between a spray foam job that lasts and one that fails comes down to the contractor. Lapolla Industries applies the same quality standards to every metal roof coating project that earned us a reputation as one of the nation's most trusted SPF specialists — proper surface prep, correct foam thickness, and factory-specified coating application.
Every metal roof coating project we complete in New Ulm is backed by both manufacturer material warranties and our own workmanship guarantee. We document every step with photos and measurements, provide you with a detailed project report, and remain available for warranty service and maintenance throughout the life of your SPF system.
Our proven process ensures quality results on every spray foam project.
Our assessment process goes beyond a visual check. We examine substrate conditions, drainage patterns, existing insulation performance, and structural integrity. This data-driven approach ensures we recommend the right spray foam solution for your specific property.
Our preparation process includes substrate inspection, cleaning, moisture testing, and priming. We mask all areas not receiving foam, set up containment where needed, and verify that temperature and humidity conditions are within specification for application.
Our factory-trained crews apply spray polyurethane foam using calibrated equipment that ensures consistent thickness, proper density, and complete coverage. The foam expands on contact, fills every gap, and bonds permanently to the prepared substrate.
The final step is applying a protective topcoat that shields the SPF from UV exposure and provides the weather surface. We select the coating type based on your roof slope, ponding conditions, and desired service life. After coating, we clean up completely and review the finished project with you.
Common questions about metal roof coating answered by our spray foam experts.
Costs for metal roof coating in New Ulm vary based on project size, existing conditions, and material requirements. We provide free on-site estimates with detailed written proposals. Contact us at {phone} for a no-obligation quote.
Yes. Every Lapolla Industries crew working in New Ulm is fully licensed, bonded, and insured for spray foam application. We carry general liability and workers compensation coverage on every project and can provide proof of insurance upon request.
Yes. Every metal roof coating project in New Ulm is backed by manufacturer material warranties plus our own workmanship guarantee. We handle all warranty registration and remain available for warranty service throughout the life of your system.
Absolutely. Once cured, spray polyurethane foam is inert and non-toxic. Our New Ulm crews follow all OSHA safety protocols during application, including full PPE and ventilation procedures. The foam cures within minutes and is safe immediately after.
See what customers across the country say about working with Lapolla Industries.
"Our commercial building needed a roof solution that would not require tenant relocation. The restoration approach was perfect — no tear-off noise or debris, minimal odor, and a fully warranted system installed in under two weeks."
"Had a few spots where birds had pecked through the coating on our foam roof. The repair crew patched every spot and applied a fresh topcoat over the entire section. Looks brand new and no more leaks."
"We needed our concrete roof deck waterproofed before installing new equipment on it. The crew applied a monolithic membrane that handles foot traffic and ponding water. Two years in and zero issues. Money well spent."